I have these two raised panel garage doors to refinish on a lake rental house. Just testing a couple of panels, it won't be too bad sanding down to bare wood, but someone had put another coat of marine varnish on the bottom two sections, so those are going to get some work with a heat gun before...
Last Post By: John TenEyck Today, 7:34 PMAll these slider threads got me thinking. Does anyone here have the Harvey compass st-1500 attached to their unisaw? Can you speak on the quality, ease of attachment, capabilities and shortcomings? Thank you in advance!
Last Post By: Michael Zerance Today, 7:46 PMhttps://www.cnn.com/2024/05/07/business/swiss-army-knife-blade-scli-intl/index.html While I understand the decision, I can't help think that, I carry a pocket knife, with a blade only and use it for so many tasks. I think I would be fumbling through the selection of tools trying to find a...
Last Post By: Jim Koepke Today, 7:54 PMI have a 1/2" sorby detail gouge that I have ground at 40° (also removed the heel) and it works ok now that I moved away from the jigs and started sharpening by hand... but it's still just an ok tool. I now have a d-way detail spindle gouge (1/2") on the way and was thinking about trying a 25°...
Last Post By: Don Frank Today, 8:57 AMHas any one here done one? Looking for suggestions, thanks.
Last Post By: Tom Yaegle Today, 6:11 PMAll, I have been in the market for a bigger bandsaw. Starting to build some rocking chairs a la Hal Taylor, and my PM 141 does not have enough clearance to make a few of the cuts needed. A Powermatic 80 20" had come up in my area, for a little under $1k. Owner states it runs smooth, cuts well....
Last Post By: Mickey Plunkett Today, 11:47 AMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
If the material is straight and flat, there's no real reason to take off more material prior to your glue-up. If the material has moved since you last
Jim Becker Today, 7:59 PMStephen, the primary avenue for sharing here at SMC is in the appropriate forum discussion area. Your example relative to projects would be to document
Jim Becker Today, 7:57 PMThe insert on my Grizzly has a metal pin in the rear edge that hooks under the table to prevent lifting. Maybe you could replicate that with a finish
Michael Zerance Today, 7:55 PMWhen one of my grandsons was to be given a knife, there weren't any extras in my accumulation. We went looking for a Swiss Army knife like my own and
Jim Koepke Today, 7:54 PMI'm sad you had that experience at your local SW store, Michael. It's certainly not my experience at the three that are local to me. Everyone is well
Jim Becker Today, 7:52 PM
vBulletin Message