With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Looking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something.
I ran across this in a magazine ad.
The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Saw a sign at hoe despot and looked it up. California has banned the sale of gas lawnmowers and leaf blowers after 2024. If yours is getting tired better buy a new one in a few months. I assume they will be gone from stores by Fall.
It will probably take ten to twenty years until this ban goes...
Has been restocked..
Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox...
Eight 1 x 6 x 6'
Five 1 x 4 x 6'
And he threw in a stack of shorts
And a 3/4" x 8" x 39" slab..
I am looking for what people in other jurisdictions have dealt with. I have always understood that, in my city, fences between homes were the responsibility of the homeowner who first puts it up. And the rule was "good side out" and 6" off the property line. But after a discussion with a...
Hi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions.
Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
It depends on what you're cutting. If you're resawing expensive veneer, then kerf absolutely matters. And you probably want a smooth surface to minimize
Sections
Recent Articles
Recent Polls
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Allen Yesterday, 5:25 PM