Has been restocked.. Bought 10 planks...for $30...had to cut a few of the 10 footers down, to fit into the Trunk of my Chevy Equinox... Eight 1 x 6 x 6' Five 1 x 4 x 6' And he threw in a stack of shorts And a 3/4" x 8" x 39" slab..
Last Post By: steven c newman Yesterday, 7:10 PMDue to health reasons, I can no longer use my shop, I'll be selling everything starting with my Lathe tools and the Powermatic 3520B: Woodcutter coring tool W/laser. $350 Sorby texturing tools - the complete set W/ micro set. $250 Sorby captive ring tool set (3 pc.) $60 Elbow hollowing tool W/...
Last Post By: Lee Schierer Today, 7:28 AMHi, Everyone. I dearly love this forum, although I have not posted in a long time. You folks are so knowledgeable and always have such great suggestions. Here is my situation. I make a small music accessory and need to build my own saw. Without going into all the details, I've been searching for...
Last Post By: stephen thomas Today, 9:36 AMI've got a 23 HP diesel Kioti tractor, 3 years old. As I was operating the backhoe at about 1/2 throttle, the engine suddenly over revved, smoked for less than 10 seconds and then died. I checked all fluids, temps, etc looked over the engine for any obvious problem and all was fine. To my...
Last Post By: Bill George Today, 9:51 AMIn my small shop most things are kept in drawers and anything like packaging is turfed out rather than claiming space. Tools like drills share bits etc with other drills and are easily accessed from drawers. If my router lived in a Systainer the accessories would have to live elsewhere, at least...
Last Post By: Keith Outten Today, 7:27 AMI have a Gitzo tripod that was bought in the late 1970s. The rubber ring for tightening the nut on the telescoping section to raise and lower the camera has finally stretched to the point of uselessness. Years ago when talking to a rep. at Gitzo I was told the part is unavailable and my model...
Last Post By: Jim Koepke Yesterday, 6:59 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Welcome George. HiFi projects are fun. I am sure you have found your way to Parts Express. It is amazing what's available on the web for speaker building.
Maurice Mcmurry Today, 10:34 AMHere is a picture of the last load of lumber I purchased from Irion: flitch sawn 5/4 cherry: beautiful material.
[IMG][/IMG]
Just think how difficult it would have been if you didn't have the hand tools. Lot of work but worth it. Looking good so far.
Eric Brown Today, 10:23 AMWoman without her man would be nothing
Definitely need a comma when writing that statement
As I read with dismay what's left of the local paper, I wish the editors' (if they have editors) understanding of grammar went deep enough to care about
Alan Rutherford Today, 10:20 AM
vBulletin Message