With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 9:30 AMLooking for a new project to do. I've been spending a few months upgrading the workshop / fixing minor annoyances, and really need to actually build something. I ran across this in a magazine ad. The furniture is supposedly solid teak, though I don't think that will be in the cards for...
Last Post By: Jim Becker Today, 9:42 AMI need to downsize my hobby woodworking shop a bit, and would like to have a table saw that is smaller than a cabinet saw with the extension table. Is there a smaller table saw that would still be as accurate as a cabinet saw? Most of the smaller saws are jobsite saws, and they don't seem to have a...
Last Post By: Matt Day Yesterday, 10:28 PMI'm a hobbyist on a limited budget looking for a bandsaw, primarily for resawing. Let's say, 12" of 8/4 hard maple cut down the middle would be the maximum I would ever ask of it. I'm under the impression that I'll need a steel framed bandsaw for that. What else do I need to know? Are guides...
Last Post By: John TenEyck Today, 3:19 PMThis morning I plugged in a small electric heater for the bathroom. No sign of life, figured it was either the heater or outlet. I turned off the circuit breaker (after I found it, panel is poorly labeled), removed the outlet and began poking around with a meter. Black to white was 0 volts, I was...
Last Post By: Tom M King Today, 8:10 AMhas anyone done a cope and stick micro/skinny shaker setup, or is the consensus that it's always a miter wrap? i talked to Great Lakes a while back, and they hadn't seen it (or at least my rep hadn't), curious what others have done. i would much, much rather make them on the shaper than at the...
Last Post By: Maurice Mcmurry Yesterday, 5:00 PMSure - why not? (Votes: 9)
Never. If I needed something, I'd buy or rent it. (Votes: 10)
Maybe. Depends on the person and the tool. (Votes: 52)
Same here. This is 7 or 8" white oak, but I cut 10" veneer with it, too. It takes careful setup, but it can be done, slowly.
Thanks, Cliff. Since you alerted me to the way the ashes are handled, I'm going to stop at a mortuary near me and see if they use the same size in this
Mike Henderson Today, 3:10 PMI have the DeWalt 60 volt blower. It's as good as the corded one I used to use. The batteries are a bit expensive - I have three - but they've lasted
Mike Henderson Today, 3:08 PM2 hours to saw one board? You must have some big guns to use a handsaw for 2 hours. And you are indeed a patient man. But fortunately, you don't have
John TenEyck Today, 3:07 PMPersonally I would use epoxy and medium hardener to minimize any potential warping using any water-borne glues. With a long open time of epoxy it should
Michael Burnside Today, 3:06 PM
vBulletin Message