With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
I think I'm finally going to pull the trigger on an 8" jointer. I don't have one right now and I'm tired of having to planer sled/table saw sled for jointing and not getting perfect cuts on those anyways.
Prices are all over the place between brands. I'm wanting helical and probably...
The VFD on my 120v Jet 1642 lathe burnt up and I would like to replace it with a 240v VFD. (they are smaller, cheaper, and more dependable than 120v) The only problem is that the tach requires 120v. I can put it on a separate 120v circuit, but that seems so inelegant. I would like to run a hot...
I’m thinking about getting a whole house surge protector. I’d appreciate any input from those of you who have one or anyone who has any info on them.
Thanks
I want to buy one CBN wheel. I will use my other white aluminum oxide grinding wheels: a 120-grit wheel and a 60-grit wheel for shaping for now. I think I like the 1.5 inch wide and 220 grit CBN. Does anyone think this will be a good plan? Also, how do steel CBN wheels compare to aluminum wheels...
Hi All!
My 30w fiber laser stopped firing when it was about 1/3 thru engraving an aluminum bracelet. Can anyone give some advice?
I'm using ezcad2 14.9.
Are there any fuses inside the Laser box?
Can anyone also tell me if a dialog box opens with a Agree/Disagree dialog box when you start...
Sections
Recent Articles
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Dave Anderson NH Today, 8:45 AM