With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Attention to my woodworking friends! I have a fair amount of Gaboon Ebony cutoffs I've collected over the years and I'm looking to put them to good use. I'm thinking about making a number of small Krenov style apron / block planes that would be available for sale. They would be made of Gaboon...
Oh boy, reading the archives I can see this is not a simple question, which makes me feel good because I am completely lost.
I have never owned a dust collector mostly due to inability to figure out what I need, and that needs to change. So, let me go over my shop, my needs, and then beg for...
I've been away from woodworking for about ten years while I was restoring a car. It was something wanted to do since I was a kid and I finally got it done.
Now I want to get back into woodworking and I will need a new table saw. I had been using a hot-rodded Craftsman contractor saw. It got the...
I bought a used 2019 Grasshopper diesel zero turn mower with 189 hours on it last summer. I had all kinds of problems with it initially including a starter that didn't always turn over. I realized after I bought it that the mower had been buried pretty deep in mud or something as the dashboard...
Building 6 ft high, 28 in wide, 12 inch deep solid 3/4 inch walnut bookshelf , no adjustable shelves. I have dados for all shelves. The sides are a little bowed, requiring some pressure with clamps to pull them together with the dados. Not a ton, but some. I'm trying to decide if I need to add...
Lots of walls are built with stones that are not flat/level, including angled as you show. If that stone is stable, leave it be. With or without reinforcement
Sections
Recent Articles
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: Jim Koepke Yesterday, 2:28 PM