I'm kicking around getting the Hammer K3 Winner 48x48 sliding table saw. Does anyone have one? Experience with it? Better options in the $5,000 price range? I suppose the Sawstop and the Minimax SC2 are probably the other contenders.
I'm tracking that used is always an option, just tough to...
After a long 8 weeks and 5 days my Journeyman was delivered by UPS this past Tuesday. Fortunately, everything arrived in good shape. I have to say, 1F has made assembly of the main unit very easy. They have a well written, easy to follow, assembly manual. After unpacking the three boxes it took...
I recently acquired this 1967 VW dune buggy knowing that it would be a bit of a project before I could get it on the road. It runs good just needs a tune up but I will need to replace some parts here and there to get it where it needs to be. Most of the parts are on order, new brake shoes, stuff...
I've been away from woodworking for about ten years while I was restoring a car. It was something wanted to do since I was a kid and I finally got it done.
Now I want to get back into woodworking and I will need a new table saw. I had been using a hot-rodded Craftsman contractor saw. It got the...
I bought a used 2019 Grasshopper diesel zero turn mower with 189 hours on it last summer. I had all kinds of problems with it initially including a starter that didn't always turn over. I realized after I bought it that the mower had been buried pretty deep in mud or something as the dashboard...
There is a ton of info on the web about the more common woodworking hand tools (chisels, planes, saws) but what about rasps and floats? What’s the difference in application? How do these tools fit into the tool continuum from axe to sandpaper?
What brands and models would you recommend to...
The leading edge of the cap iron should be rounded and not a flat bevel. A steep flat bevel is more susceptible to clogging, so you want the edge to be
Sections
Recent Articles
Hammer K3 Winner 48x48 thoughts?
Thread Starter: Jacob MacI'm kicking around getting the Hammer K3 Winner 48x48 sliding table saw. Does anyone have one? Experience with it? Better options in the $5,000 price range? I suppose the Sawstop and the Minimax SC2 are probably the other contenders. I'm tracking that used is always an option, just tough to...
Last Post By: Chris Parks Yesterday, 8:24 PM