• Recent Articles

  • Hottest Threads

    Patrick Walsh

    Vintage Martin T75 restoration

    Thread Starter: Patrick Walsh

    So I have a opportunity to purchase the above machine for a fair deal from my employer. I am aware of the phenolic guides being pop riveted I the the sliding table along with not availible for replacement. So my question is as follows to those in the know with regard to the phenolic ways....

    Last Post By: Patrick Walsh Yesterday, 8:13 PM Go to last post
    Dan Friedrichs

    "Professional" paint (Sherwin Williams, etc) vs Box-Store paint

    Thread Starter: Dan Friedrichs

    In our new house, I bought Valspar Signature paint from Lowe's to paint the entire interior, but ended up hiring professional painters to do the job. Nice, honest guys, who very timidly pulled me aside after putting on 2 coats of the Valspar and asked if I'd be offended if they went and bought...

    Last Post By: lowell holmes Yesterday, 12:38 PM Go to last post
    Bennie Dempsey

    3D Planning Software

    Thread Starter: Bennie Dempsey

    Hey all! I would like to start planning out my projects before I begin them, as I've heard that's a good habit to have. I can find a modeling program online pretty easily, but I wanted to see what you guys use. I am awful at hand drafting so paper and pencil isn't my go-to for personal projects....

    Last Post By: richard b miller Yesterday, 11:05 AM Go to last post
    Michael Gantz

    Hanging EMT conduit in new shop.

    Thread Starter: Michael Gantz

    I'm currently in the process of building a 24' x 36' shop with 10' ceilings. The walls are 2" x 6" studs and the cavities are filled with cellulose insulation. The walls are covered in 1/2" drywall. My intention is to minimize wall penetrations to keep air leaks to a minimum. The plan is to...

    Last Post By: Julie Moriarty Yesterday, 1:19 PM Go to last post
    Dave Lehnert

    New Zero Turn Mower

    Thread Starter: Dave Lehnert

    Starting to think about a new Zero Turn Mower. I now own a Toro 52" with a 19 Hp Kawasaki that I have been happy with. Mow 2 1/2 acr all flat. What brand have you been happy with? More important. Is there a brand you have had trouble with? Parts hard to get etc.....

    Last Post By: Ronald Blue Yesterday, 12:50 PM Go to last post
    Jack Hovanec

    "Drop cutting" on a shaper

    Thread Starter: Jack Hovanec

    Hey guys, I am working on a project that requires three mahogany stop-fluted half columns. The columns are 6 3/4 wide and I already got a knife ground that will do two flutes at a time (There are 4 total flutes on the face, 1/2" radius). My question is: how does one safely and efficiently "drop...

    Last Post By: Joe Calhoon Yesterday, 10:42 PM Go to last post