• Recent Articles

  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Ed Aumiller Today, 10:13 PM Go to last post
    ken hatch

    Bevels

    Thread Starter: ken hatch

    I asked this question on another thread. What's with the multiple bevels, over the last couple or three weeks I keep seeing mention of primary, secondary, and even tertiary bevels. Most of the time Rob Cosman is also given credit as in "sharpened as Rob Cosman does". Why? Is it a honing guide...

    Last Post By: steven c newman Today, 1:07 PM Go to last post
    steven c newman

    A Project for July?

    Thread Starter: steven c newman

    Well....I did have a stack or two of scraps... And a couple of Pine boards sitting around, doing nothing constructive And a couple handy panels of plywood.... That needed a job. Sorted through the Ash scraps....had 11 pieces, tossed out 2...They needed squared up, so they were all about...

    Last Post By: steven c newman Today, 4:43 PM Go to last post
    Derek Cohen

    Marking knives for joinery

    Thread Starter: Derek Cohen

    These are some the knives I have collected over the years and use for laying out joinery. Obviously not all at the same time :) Three popular knives - these ones get a lot of use. From the top down ... Swann-Morton fixed blade, Stanley swivel blade, and a Swann-Morton craft knife which was my...

    Last Post By: Kevin Groenke Today, 2:52 PM Go to last post
    James Williams 007

    DeWalt Radial arm saw a good purchase?

    Thread Starter: James Williams 007

    I found this old dewalt radial arm saw at a garage sale but I dont know if its a good buy. It seems to be in good shape it powers up and feels solid but I don't know enough about them to know what might need to be fixed or if its worth the 100 bucks the guys asking. My grandpa had one and I've...

    Last Post By: Frederick Skelly Today, 7:34 PM Go to last post
    Jim Koepke

    Was it just my imagination?

    Thread Starter: Jim Koepke

    Was there a recent post on the "Unicorn Edge" or some such? Having looked at another forum to see what this was about, it was put on a back burner to give a try. Finally had a plane blade to give it a try. It did provide a very good edge able to make an incredibly thin shaving on a piece...

    Last Post By: Winston Chang Today, 10:16 PM Go to last post