• Sawmill Creek News RSS Feed

    by Published on 02-27-2011 5:33 PM     Number of Views: 18094 

    Do you have woodworking knowledge you're just dying to share?
    Want to be an author at Sawmill Creek?

    Now you have a new area to publish articles!

    If you want to publish an article, you can join our authors group, which gives you access to a forum which is open only to would-be authors at SawmillCreek. This is a staging area for new articles, where you can post a new article, and we'll review for publication. Once you're ready to publish it, we'll promote it on the front page of SawmillCreek!


    The process is simple:

    1. Join the Authors group by visiting this page.
    2. Once you have access, visit the Authors forum.
    3. Start your article by creating a new thread in that forum.


    TIPS

    If your article is too long for a single post, don't fret ! Spread your article over multiple posts, and we'll merge them together into a single post when the article is ready to be published.

    Try posting pictures inline for visual interest.

    Choose a catchy, yet descriptive title!

    Writer's Block?

    We're looking for tool reviews, woodworking tips, woodturning techniques, jigs and fixtures, finished projects step-by-step, finishing techniques, social woodworking experiences, and even good compilations of our existing thread topics.

    Good luck and Happy writing!
    _Aaron Koehl_

  • Recent Forum Posts

    Daniel Kluk

    Dewalt MBF 248

    I am up to 100 after just buying this one for $150. Did a new table and it looks perfectly sq.
    Its a delta 20a smaller one. My objective was to

    Daniel Kluk Today, 6:46 PM Go to last post
    roger wiegand

    Wood turning blanks online

    I wrote a long response, but it vanished. I guess I forgot to push the send button.

    Drying thick wood takes forever and then it is hard

    roger wiegand Today, 6:44 PM Go to last post
    Tom Bain

    roasted hard maple

    Jim -- I hear you ... I typically use Unibond (plastic resin) for any bent lamination work regardless of whether it's indoor or outdoor, because of the

    Tom Bain Today, 6:37 PM Go to last post
    Eli Akin

    I 'm confused...

    I have been using a standard type 9 Bailey number 4 for a while. I LOVE it. I only paid $30 for it and I have restored it and I can take beautiful shavings

    Eli Akin Today, 6:36 PM Go to last post
    Dave Sabo

    Sanding Swirls with festool ETS 150

    Too large and orbit and not a high enough grit to get rid of previous marks.

    To much suction can also contribute.


    Dave Sabo Today, 6:34 PM Go to last post