• Sawmill Creek News RSS Feed

    by Published on 02-27-2011 5:33 PM     Number of Views: 14735 

    Do you have woodworking knowledge you're just dying to share?
    Want to be an author at Sawmill Creek?

    Now you have a new area to publish articles!

    If you want to publish an article, you can join our authors group, which gives you access to a forum which is open only to would-be authors at SawmillCreek. This is a staging area for new articles, where you can post a new article, and we'll review for publication. Once you're ready to publish it, we'll promote it on the front page of SawmillCreek!

    The process is simple:

    1. Join the Authors group by visiting this page.
    2. Once you have access, visit the Authors forum.
    3. Start your article by creating a new thread in that forum.


    If your article is too long for a single post, don't fret ! Spread your article over multiple posts, and we'll merge them together into a single post when the article is ready to be published.

    Try posting pictures inline for visual interest.

    Choose a catchy, yet descriptive title!

    Writer's Block?

    We're looking for tool reviews, woodworking tips, woodturning techniques, jigs and fixtures, finished projects step-by-step, finishing techniques, social woodworking experiences, and even good compilations of our existing thread topics.

    Good luck and Happy writing!
    _Aaron Koehl_

  • Recent Polls

    Which Coping Sled is the Best (Votes: 45)

    1. Woodpeckers Coping Sled (Votes: 16)

    2. Infinity Professional Coping Sled (Votes: 16)

    3. Neither - Who needs a sled anyway? (Votes: 11)

    4. Both - Why buy only one when you can have two at twice the price? (Votes: 2)

  • Recent Forum Posts

    Martin Wasner

    Minnesota Milling

    Is it the same as Matt Collins business? His family has a tree service and does sawing and drying.

    Martin Wasner Today, 7:46 PM Go to last post
    Barb Becker

    Looking for exhaust suggestions for Speedy 360

    Thanks, Bill and Kev!! I did post on the Trotec FB group too so will see what others have done, but I felt sure you guys would come up with something

    Barb Becker Today, 7:45 PM Go to last post
    steven c newman

    Next Build?

    Ok, Fancy tenons need a place to go..
    Mark out, and rough cut....

    Set up the mortise jig.

    Chop a mortise...

    steven c newman Today, 7:42 PM Go to last post
    Joe Kendal

    Minnesota Milling

    Before you buy from Minnesota milling you better read the Better Business Bureaus complaint form on him, it's BAD

    Joe Kendal Today, 7:35 PM Go to last post
    steven c newman

    Next Build?

    Dropping back here, yet again....thread iS getting a bit long winded, eh?
    Two work sessions today...Morning involved changing out the skinny bandsaw

    steven c newman Today, 7:34 PM Go to last post