• Recent Articles

  • Recent Article Comments Widget

    Amy Gilron

    Using CA Glue in Woodturning

    Recently, my glasses frame sheared off at the ear piece when I was traveling. I fixed it using CA... Go to last post

    Amy Gilron Yesterday 3:03 PM
  • Hottest Threads

    Dave Anderson NH

    Time for some levity

    Thread Starter: Dave Anderson NH

    With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.

    Last Post By: Jim Allen Yesterday, 4:45 PM Go to last post
    glenn bradley

    A Building Appears

    Thread Starter: glenn bradley

    My patience is tested by the 2-pics-at-a-time feature so this will be brief.

    Last Post By: glenn bradley Yesterday, 12:03 PM Go to last post
    John Terefenko

    Electric Cars

    Thread Starter: John Terefenko

    For those that own electric cars a few questions?? Do you like your choice as opposed to having a gas operated one? Would you do it again? Did you have to make changes to your insurance plans, both vehicle and home? If so what? Being there is a higher risk with battery fires from charging and now...

    Last Post By: Jim Becker Today, 9:24 AM Go to last post
    Mark Rainey

    Handplane courage

    Thread Starter: Mark Rainey

    OK, Neanders, I admit, I used sand paper. I am making a dining room table and handplaned the top. Leveled with the jack, smoothed with a Clifton #3 Blade so gently sharpened to reduce edges...gossamer shavings, looking great. Used a scraper. I put a raking light on the top and I saw plane...

    Last Post By: Derek Cohen Today, 9:01 AM Go to last post
    Dan Gaylin

    Sharpening: what am I doing wrong

    Thread Starter: Dan Gaylin

    Hi all, I have become really discouraged with my latest attempts at sharpening, and would appreciate your advice. I have a full set of diasharp diamond sharpening plates (extra-extra coarse to extra fine) and then float glass with 3M PSA lapping films from 5 microns to .3 microns. I use the...

    Last Post By: Kevin Jenness Today, 9:45 AM Go to last post
    Ron Hampe

    Laguna vacuum pumps

    Thread Starter: Ron Hampe

    Are they worth buying? They have a 2.5hp (109cfm/3.7"Hg) single phase for $900 and I would need 3 or 4 of those for my 49" x 98" table. By installing these with an isolated zone for each I believe the advantage would be a lower operating costs when cutting smaller parts. They also have a...

    Last Post By: joe f griffin Yesterday, 10:16 AM Go to last post