With all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Attention to my woodworking friends! I have a fair amount of Gaboon Ebony cutoffs I've collected over the years and I'm looking to put them to good use. I'm thinking about making a number of small Krenov style apron / block planes that would be available for sale. They would be made of Gaboon...
I thought about posting this to the business section, because I'd really like input from professionals who use their shop as a business. For those of you who make $ or even a living making furniture or cabinets, how long does it take for a sliding table saw to pay for itself compared to a track saw...
Building 6 ft high, 28 in wide, 12 inch deep solid 3/4 inch walnut bookshelf , no adjustable shelves. I have dados for all shelves. The sides are a little bowed, requiring some pressure with clamps to pull them together with the dados. Not a ton, but some. I'm trying to decide if I need to add...
I wish I had bought the lift lock and roll mobility device which apparently is not made anymore. Does anyone know where I could get one or have one to sell? I need it for my PM 3520 B
I've been away from woodworking for about ten years while I was restoring a car. It was something wanted to do since I was a kid and I finally got it done.
Now I want to get back into woodworking and I will need a new table saw. I had been using a hot-rodded Craftsman contractor saw. It got the...
Hi folks. I have a stereo rack that is finished in lacquer. I will be putting heavy audio equipment on it and the components will have rubber and sorbothane
Have also thought along the same lines for the shop-I-can't-quite-pull-the-trigger-on-yet. Are you thinking of gluing the mat down or letting it float?
I have a Hitachi c10FSH. It has been a very good saw with some limitations like the limited height to cut baseboard standing up. I had some issues with
Sections
Recent Articles
Time for some levity
Thread Starter: Dave Anderson NHWith all of the negativity and political stuff going on with the Covid-19 virus it is time to look at the humorous side of things. Feel free to add more, but keep it clean or it will be deleted.
Last Post By: John Ziebron Today, 10:58 AM