• Recent Articles

  • Recent Article Comments Widget

    Amy Gilron

    Using CA Glue in Woodturning

    Recently, my glasses frame sheared off at the ear piece when I was traveling. I fixed it using CA... Go to last post

    Amy Gilron Yesterday 3:03 PM
  • Hottest Threads

    John Terefenko

    Electric Cars

    Thread Starter: John Terefenko

    For those that own electric cars a few questions?? Do you like your choice as opposed to having a gas operated one? Would you do it again? Did you have to make changes to your insurance plans, both vehicle and home? If so what? Being there is a higher risk with battery fires from charging and now...

    Last Post By: Steve Demuth Today, 6:33 PM Go to last post
    Mark Rainey

    Handplane courage

    Thread Starter: Mark Rainey

    OK, Neanders, I admit, I used sand paper. I am making a dining room table and handplaned the top. Leveled with the jack, smoothed with a Clifton #3 Blade so gently sharpened to reduce edges...gossamer shavings, looking great. Used a scraper. I put a raking light on the top and I saw plane...

    Last Post By: Derek Cohen Today, 9:01 AM Go to last post
    Dan Gaylin

    Sharpening: what am I doing wrong

    Thread Starter: Dan Gaylin

    Hi all, I have become really discouraged with my latest attempts at sharpening, and would appreciate your advice. I have a full set of diasharp diamond sharpening plates (extra-extra coarse to extra fine) and then float glass with 3M PSA lapping films from 5 microns to .3 microns. I use the...

    Last Post By: Jim Koepke Today, 4:16 PM Go to last post
    roger wiegand

    Bandsaw tensioning redux

    Thread Starter: roger wiegand

    I've plowed my way through more than I ever wanted to know on the topic.. (eg https://sawmillcreek.org/showthread.php?50949-Carter-Iturra-Lenox-Starrett-Comparison/page7) as well as later threads. On my little bandsaw I can twang on the blade and guess that the tension will be about right for...

    Last Post By: Tom Trees Today, 1:09 PM Go to last post
    Derek Arita

    Table Top Veneer Help

    Thread Starter: Derek Arita

    So I made an MDF work table top that I'd like to cover with a black, water resistant veneer of some sort. Also, its a work table, so I don't want to spend much $ on it. I know nothing about veneers or what's available, so I really need some help. My first thought was some kind of formica, but...

    Last Post By: Mark Bolton Today, 9:50 AM Go to last post
    John Terefenko

    Battery Jumpers

    Thread Starter: John Terefenko

    After reading all the stories in the Electric Car thread, I started thinking what is the best 12 volt battery jumper for emergency jumps. You know these battery packs that you can carry in the trunk. Do they work and what are the do's and dont's with them? Are they worth it. I see ones advertised...

    Last Post By: Edward Weber Today, 11:13 AM Go to last post