All Blog Entries

I learn something new from each project. Usually, it is how not to do something. In this case, I didn't label my pieces as well as I might have, so I ended up with a bit of a mess-up in one joint. Luckily, this is when to do it. In any case here are the two concepts:

Here are the completed views of the arc / leg assembly. First, slightly proud back, proud front.

DSCN1027.jpgDSCN1029.jpgDSCN1030.jpg

Second, ...

After I get the concepts more or less set, I start to think practical. The first thing do (usually mentally), is figure out a draft sequence of operations. Here is my initial concept for this project.

Initial sequence thoughts

1. Legs Bandsaw curve & retape
2. Legs cut top angle
3. Legs Cut slot for bridle joint
4. Legs bandsaw taper & retape
5. Arc cut bridle joint dado
6. Arc bandsaw curve and retape
7. Arc taper ends
8. Arc & Legs router trim

...

Attached Images

• DSCN1027.jpg (82.7 KB, 24 views)
• DSCN1029.jpg (56.5 KB, 23 views)

LOML wanted to see a lower shelf on the tall version. What LOML wants, she gets.

DSCN0993.jpgDSCN0994.jpgDSCN1000.jpg

I then tape them up to the wall to review and consider for a while.

DSCN0997.jpgDSCN0996.jpg

With all of this there was no clear winner. I liked both the tall version and the shorter version. What to do then? Of course, mock up each.

After sitting on the idea for a while, I decided it stall had merit. So the next step is to draw it up. I tend to work in 3"=1'-0" scale for a project of this size. I had initially conceived of this as a small table to sit by the couch that LOML might put her magazines or laptop on. I first drew it up as if it were right for that purpose. I chose to start with it being square in proportion when viewed from the front. I draft it out out in proportion and then sketch over it in trace. Here ...

Attached Images

• DSCN1000.jpg (61.1 KB, 18 views)

i have had my new/used Excalibur EX-21 scroll saw for about a month now and im finally starting to get the hang of it.
it needed a few things at first and still does but im happy with the way its running and i have made a few nice items.
this saw really lives up to its reputation! very very solid saw, the tilting head is a great feature.
i need to find a good magnifier/light to use with the saw along with a small vac for dust collection.
i just wish it was still painted ...