Recent Blogs Posts

Originally Posted by Zac wingert

D1FF67FD-5CB9-4B17-B084-197F837DE16C.jpg

Here is the box it was in.

That is a product with the Witherby name and likely nothing to do with the T H Witherby legacy, at least to my knowledge.

It may be someone who had rights to use the name. It may be the trade mark to the name has become public domain.

There is also Witherby Publishing, seems to be mostly maritime titles.

More research would be in order if it is something you have to ...

Originally Posted by dennis thompson

Went to Home Depot on Saturday to buy the Ridgid R4512 saw. Worked with two different associates, both of whom were completely useless, I wanted to make sure the saw was made in 2016, after the trunnion issue was fixed. Left the store completely annoyed with them. I really wanted the saw so I went back early Sunday morning and asked for the manager. It was like I was in a different store, the manager and his assistant were great. They got a fork lift to get the saws down from a high rack, allowed

...

(Continued) After the fit is good, The leaves are glued in. After they dry, I scrape off the paper.

Placing Ebony.jpgCut Ebony.jpgInlay Prior to Scraping.jpg

I then cleaned up the surface and shot the edges. A Coat of BLO and let to dry overnight.

Shooting Edges.jpgCoat of BLO.jpg

Now I need to figure out what to do with the panel. I'm thinking I will re-saw it and make it a door for a ...

I am down to the part I have been dreading, the inlay. I have always liked the Japanese Brush and Ink Drawings. I travel with a sketchbook, brushes and pens. I found I was interested in this type of motif could be added to a cabinet. Here is a concept sketch.

Brush and Ink.jpg

I then spent a bit of time scaling this and composing it on the box.

Concept.jpg

So, I thought I would do a practice panel to ensure I was ...

Well the end seems in sight now. I have a coat of finish on the legs. I also fastened the top handle. So next it was mortising of the hasps and then fashioning the attachment plate.

I cut the mortises for the hasps. I rough out with my Dremel set up for inlay and then pared carefully with a chisel to my layout lines. After mortising, I put a coat of finish down to avoid getting finish on the hasps. I had cast the hasps last fall from bronze. That was a bit frustrating as twice I cracked ...