View RSS Feed

All Blog Entries

  1. The blow-out

    Anyone who knows me recognizes that the router is my least favorite tool. It can be the right tool for the right job, but I will go a long way to avoid using them. Because of the nature of the piece and the joinery required, I was going to use the router to trim all of the legs to the template I created. This would allow me to cut the dados on the arc ahead of time and still be assured that they would form a tight joint. Because I was doing two pieces at the same time, I wanted to make the pieces ...
    Categories
    Uncategorized
    Attached Thumbnails Attached Images
  2. Stepping Back

    After I posted the last Blog entry I worked on the prong end. The prototype had left me with corrections to the sequence of operations but I couldn't (or shouldn't) go further without determining how I was going to fabricate the prong ends. They needed to be removable and of a tight tolerance given the nature of the design intent. I drew many different joints out at full scale but ultimately decided on a sliding dovetail connection. I mocked this up in poplar as well taking notes along the way. ...
    Categories
    Uncategorized
    Attached Thumbnails Attached Images
  3. First learnings

    I learn something new from each project. Usually, it is how not to do something. In this case, I didn't label my pieces as well as I might have, so I ended up with a bit of a mess-up in one joint. Luckily, this is when to do it. In any case here are the two concepts:

    Here are the completed views of the arc / leg assembly. First, slightly proud back, proud front.

    DSCN1027.jpgDSCN1029.jpgDSCN1030.jpg

    Second, ...
    Categories
    Uncategorized
  4. The mock-up and choices

    After I get the concepts more or less set, I start to think practical. The first thing do (usually mentally), is figure out a draft sequence of operations. Here is my initial concept for this project.

    Initial sequence thoughts

    1. Legs Bandsaw curve & retape
    2. Legs cut top angle
    3. Legs Cut slot for bridle joint
    4. Legs bandsaw taper & retape
    5. Arc cut bridle joint dado
    6. Arc bandsaw curve and retape
    7. Arc taper ends
    8. Arc & Legs router trim
    ...
    Categories
    Uncategorized
    Attached Thumbnails Attached Images
  5. Design Process - My approach (Design Developement continued)

    LOML wanted to see a lower shelf on the tall version. What LOML wants, she gets.

    DSCN0993.jpgDSCN0994.jpgDSCN1000.jpg

    I then tape them up to the wall to review and consider for a while.

    DSCN0997.jpgDSCN0996.jpg

    With all of this there was no clear winner. I liked both the tall version and the shorter version. What to do then? Of course, mock up each.
    Categories
    Uncategorized
Page 7 of 28 FirstFirst ... 3456789101117 ... LastLast