Drew Eckhardt
12-13-2008, 10:13 PM
I have a box where I've ended up .010" shy of where I need to be on the inside for my miters to close.
How much of a gap can I fill with T88 before I need to start adding wood flour?
Do I need to do any sort of pre-coating on end-grain joints like this in Baltic birch plywood (marine grade)?
The bottom is a birch frame which mates to an inset piece of plywood with a shiplap, with the sides having a 1/4" overlap with the plywood. The plywood is nearly flat but took a little pressure at a couple of the corners for the joints to close in a dry fit; how much pressure is too much for the epoxy?
How much of a gap can I fill with T88 before I need to start adding wood flour?
Do I need to do any sort of pre-coating on end-grain joints like this in Baltic birch plywood (marine grade)?
The bottom is a birch frame which mates to an inset piece of plywood with a shiplap, with the sides having a 1/4" overlap with the plywood. The plywood is nearly flat but took a little pressure at a couple of the corners for the joints to close in a dry fit; how much pressure is too much for the epoxy?