Tom Godley
12-09-2008, 2:50 AM
I have a PM 2000 TS with the 50 inch fence.
The fence extension is basically a plywood torsion box with a laminate top.
The top has warped a little bit so that the center of the edge along the cast wing is raised. The fence hits this lip!
Has anyone had a similar issue?
The edge of the cast wings do not have any holes taped into them. When I put it together I thought it was a bad design. There is no way to attach the extension to that edge of the wing.
I have never tried to drill into a cast wing - I was thinking that maybe I could clamp the table flat and drill through the wood and into the cast wing. I could then tap the hole or used a bolt and nut.
How difficult is it to drill cast iron.
The fence extension is basically a plywood torsion box with a laminate top.
The top has warped a little bit so that the center of the edge along the cast wing is raised. The fence hits this lip!
Has anyone had a similar issue?
The edge of the cast wings do not have any holes taped into them. When I put it together I thought it was a bad design. There is no way to attach the extension to that edge of the wing.
I have never tried to drill into a cast wing - I was thinking that maybe I could clamp the table flat and drill through the wood and into the cast wing. I could then tap the hole or used a bolt and nut.
How difficult is it to drill cast iron.