Joseph Ezerskis
06-09-2004, 1:13 PM
Hi all!
I'm trying to use my PC b' joiner for the NYW router project. I'm trying to slot the back panel of the carcass, and I can't get closer than 6" to the outside panels. Regardless of what the project is it's still a box with boxes in it. The side panels are dado'd by 3/4" so the back piece will be flush with the sides. I'd like to put a #20 in the horiz. piece within a couple of inches of the sides, but the fence, and the knobs on it hit the sides. Is it possible to remove the fence and get closer and still hit it square? The other option that I can think off is just using a couple of screws, but I'd like to avoid that if possible.
Thanks,
Joe
I'm trying to use my PC b' joiner for the NYW router project. I'm trying to slot the back panel of the carcass, and I can't get closer than 6" to the outside panels. Regardless of what the project is it's still a box with boxes in it. The side panels are dado'd by 3/4" so the back piece will be flush with the sides. I'd like to put a #20 in the horiz. piece within a couple of inches of the sides, but the fence, and the knobs on it hit the sides. Is it possible to remove the fence and get closer and still hit it square? The other option that I can think off is just using a couple of screws, but I'd like to avoid that if possible.
Thanks,
Joe