Jay Yoder
11-29-2008, 10:24 PM
I need to remove some dried glue from the bottom of a drill press fence I put together and was wondering my options? Obviously i need to keep it square. I was thinking that I have the following options:
- Joint the whole assembly on the joiner
- Use my hand planer for bulk, then true it up on joiner
- Try to sand the joint (either by hand, or ROS, Or palm sander)
- Joint the whole assembly on the joiner
- Use my hand planer for bulk, then true it up on joiner
- Try to sand the joint (either by hand, or ROS, Or palm sander)