Anthony Welch
11-29-2008, 12:17 PM
I was cutting some vector Ornaments last night, when I heard a bang noise from the engraver. the laser carriage was off the table grid and still cutting.
I've cleaned the encoder strip, re ran same file and a raster only file and the carriage slams into the opposite side and cuts off the table. The carriage and bar acts as though it is in disable mode that I can move it around freely.
Any ideas and help would certainly be appreciated.
Thanks
Anthony
I've cleaned the encoder strip, re ran same file and a raster only file and the carriage slams into the opposite side and cuts off the table. The carriage and bar acts as though it is in disable mode that I can move it around freely.
Any ideas and help would certainly be appreciated.
Thanks
Anthony