Albert Nix
11-27-2008, 5:48 PM
I have spent most of the afternoon tring to edit an ornament so I can Raster/Cut it out. I have had this problem before and fixed it but this time I think it is going to whip me. There are cut outs on the inside and it needs to be cut out on the outside. As always you have to get ride of the red line that seem to apear in the middle of the black that is to be rastered to keep the laser from cutting down the center of a black line.
All went well until I tried to get rid of the red line that apears in the black out line. I cant make it go away. I have tried everything that I know of. On the rest of th image I just outlined with red then seperated the outline then uncompounded then deleted the unwanted red line but on luck.
Any Ideas: Al
All went well until I tried to get rid of the red line that apears in the black out line. I cant make it go away. I have tried everything that I know of. On the rest of th image I just outlined with red then seperated the outline then uncompounded then deleted the unwanted red line but on luck.
Any Ideas: Al