Rich Engelhardt
11-27-2008, 11:29 AM
Hello,
Forgive the crude photography.
Also forgive that the table and the cart are still a work in progress.
The table is a full 48" wide with the wings flipped up & 11" deep.
From past experience, I found I had more use for "wide" than "deep", so 11" is fine.
The wings on each side are attached with piano hinges and fold down for "flipping" the DP for the planer.
I use a bungie cord to hold them when I flip it over.
The fence & the t-track hold the wings in the open position.
On the bottom of the table I used threaded inserts and 1/4" bolts to attach it to the DP for the time being.
I'll add either a round off-set insert or square insert as soon as time allows.
Forgive the crude photography.
Also forgive that the table and the cart are still a work in progress.
The table is a full 48" wide with the wings flipped up & 11" deep.
From past experience, I found I had more use for "wide" than "deep", so 11" is fine.
The wings on each side are attached with piano hinges and fold down for "flipping" the DP for the planer.
I use a bungie cord to hold them when I flip it over.
The fence & the t-track hold the wings in the open position.
On the bottom of the table I used threaded inserts and 1/4" bolts to attach it to the DP for the time being.
I'll add either a round off-set insert or square insert as soon as time allows.