Teknatool chuck question

[Harvey Schneider]

Can anybody tell me what size screws are used to attach jaws on Teknatool chucks? I think they are either M5-.8 or M6.1, but the head size appears to be 10.5mm which is too large for the first and too small for the latter.

[Chuck Jones]

I don't know the exact sizes but I'll be happy to measure mine tomorrow when I go back to my shop. (However, I'm guessing you have some of the screws and having trouble measuring them precisely.)

I found the screw on Tecnatools site http://www.teknatool.com/products/Chuck_Accessories/SpurCenter.htm but don't see any way to purchase directly from them.

There is a pointer to a maintenance site is the states http://www.timstoolcrib.com/

But again I don't see any way to order them on-line. You could probably call these folks and find out the size and where to buy them.

I thought I had seen them on Woodcraft or Packard's site, but I'm not able to find them now.

I've had in mind to find an extra set because I know sooner or later one is going to roll in that spot where it will never be recovered.

[Chuck Jones]

After a second look I did find how to order the screws from Technatool. It's on their index on the left side as "On-Line Ordering". $9.99 for a set. I'm ordering one tonight so I won't have to go through this searching again next time I think of it.

[Chuck Jones]

I received the following reply this morning... after I order a set from Technatool last night for $10,

YES, I HAVE THEM IN STOCK FOR $2.10 FOR A PAK OF 8

Regards,
Tim Geist
T. V. Geist Manufacturing Inc; Representative for Teknatool International Ltd
Smart Tools, Powerful Solutions
Web Site: www.timstoolcrib.com (http://www.timstoolcrib.com)

Hours: 6:00am - 2:30pm EST
Phone/Fax: (304) 295-8166 (Please note these are on the same line, so please let it ring)
Visa and Mastercard accepted