View Full Version : Jig Grinding help Needed
Jon Lanier
11-02-2008, 9:00 PM
Does anyone know where I can get the pattern for this Fingernail Jig so I can use it with my Wolverine System?
http://img79.imageshack.us/img79/4961/fingernailgrindattachmeft4.jpg
Ken Fitzgerald
11-02-2008, 9:14 PM
Jon,
Check this link: http://www.turningtools.co.uk/widgets/grindingjig/grindjig.html
there's a pdf file about 1/2 down the page.
Gordon Seto
11-02-2008, 9:19 PM
You may measure off from this pdf copy. It is to scale.
http://www.thompsonlathetools.com/images/extra/Sharpening.pdf
Ken Fitzgerald
11-02-2008, 9:19 PM
Jon,
Here's a slightly different one with step by step instructions.
http://www.aroundthewoods.com/sharpening03.html
Don Carter
11-02-2008, 9:20 PM
What about this page?
http://ebenisteriepatton.50megs.com/Techniques%20et%20videos/Vari-Grind%20Tool%20rest.pdf
Not sure if this is what you need. I use the one that Darrell Feltmate makes, it is a square block with a dowel and hole in it. It is at http://www.aroundthewoods.com/
Hope this helps.
All the best.
Don
Jon Lanier
11-02-2008, 9:35 PM
What about this page?
http://ebenisteriepatton.50megs.com/Techniques%20et%20videos/Vari-Grind%20Tool%20rest.pdf
Don
Thanks everyone!!! Don, I think that is the one I'm looking for... if that was going to show up, I thought I'd go with the "Around the Woods" design.
-Jon
Leo Van Der Loo
11-02-2008, 10:21 PM
Yes Don that's the one,and here's the site address, though Jean did pas away several years ago, the site has been kept up.
There are several other good ideas in there,
http://www.atbq.qc.ca/jm2/woodturnjigs.htm
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.