John Nowack
10-16-2008, 10:21 PM
I was reading Bob Hallowell's tutorial on turning peppermills----here is my delima----My glue up will end up being 11.5L x 3.75W----I need the final ruff turned blank to be at least 11 inchs long by 2.5 wide (this is following the instructions and not turning the top seperatly like bob---it is to late for that because my boards are to short already)
It does not appear that I will end up with the blank being long enough once I turn it down if I off center it enough to make the seems twisted rather than just straight
ok sorry after all that--here is the readers digest version
DO YOU THINK I WILL END UP WITH A 11inch ROUND BLANK IF I OFfFCENTER TURN A 11.5 inch sqaure blank (geuss I can always go buy shorter mechanisms)
It does not appear that I will end up with the blank being long enough once I turn it down if I off center it enough to make the seems twisted rather than just straight
ok sorry after all that--here is the readers digest version
DO YOU THINK I WILL END UP WITH A 11inch ROUND BLANK IF I OFfFCENTER TURN A 11.5 inch sqaure blank (geuss I can always go buy shorter mechanisms)