John Hixon
10-16-2008, 6:12 AM
Just wanted to share an idea we came up with.
I had a problem with the new setup, needing featherboards at the router to hold material against the Incra fence.
I took a 2x4 and ripped each edge so as to be nice and square, fastened two old featherboards with screws. (flush with the back so the pressure would end up on the fence, not the screws).
Clamp this contraption to the TS fence and slide the fence up to where it is needed. Completely adjustable and the two fences are parallel.
I had a problem with the new setup, needing featherboards at the router to hold material against the Incra fence.
I took a 2x4 and ripped each edge so as to be nice and square, fastened two old featherboards with screws. (flush with the back so the pressure would end up on the fence, not the screws).
Clamp this contraption to the TS fence and slide the fence up to where it is needed. Completely adjustable and the two fences are parallel.