View Full Version : Red-Yellow Laserable Plastic?
Bill Jermyn
10-14-2008, 12:39 PM
Does anyone know of a supplier of laserable 1/16 plastic, yellow with a red core?
Joe Pelonio
10-14-2008, 1:07 PM
Rowmark and IPI will custom-make whatever you want. Rowmark 922-607 is the opposite, unfortunately, and IPI has no such combination off the shelf.
Try e-mailing Rowmark at
customerservice@rowmark.com
and for custom IPI plastics contact a local dealer.
For a small job I'd merely spray yellow Krylon Fusion onto white with the red core.
Bill Jermyn
10-14-2008, 1:33 PM
Thanks, Joe. I'd do that but I only need a couple of quarter sheets. I think their minimum is 8 or 10 sheets.
Doug Bergstrom
10-14-2008, 2:23 PM
Just reverse etch the Rowmark.
Gary Hair
10-14-2008, 3:24 PM
Thanks, Joe. I'd do that but I only need a couple of quarter sheets. I think their minimum is 8 or 10 sheets.
Last time I checked their minimum was either 1 or 2 sheets. I think 8/10 was from a long time ago.
Gary
Tony Lenkic
10-14-2008, 6:28 PM
Bill,
New Hermes has that combination in regular matte Gravoply 2. It lasers OK (the cap is thin).
Part No. 238-226
You can get this from Engravers Depot in Mississauga, On.
Bill Jermyn
10-14-2008, 7:35 PM
Thanks, I'll give that a try
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.