View Full Version : Craftsman RAS Accesories
Joe Maitland
10-13-2008, 9:55 PM
I have been trying to locate a router mount for my 10" Craftsman RAS model 113.23100. Are these rarer than hens teeth or can anyone direct me where I could find one?
Joe Maitland
Jim O'Dell
10-13-2008, 10:50 PM
Are you talking about something that will mount to the threaded shaft opposite the blade arbor? IMO, the RAS does not spin fast enough for most router bits. I guess it would be ok for some big honkers, but normal round overs and such would have a hard time at that speed. I did use a molding head for mine one time. Scared the hooey out of me. And ripping with the RAS doesn't bother me. I'd say invest in a small router table. Jim.
Denny Rice
10-13-2008, 11:13 PM
I agree with Jim!! The visions that idea puts in my mind, scary! :eek:
Joe Maitland
10-14-2008, 8:03 AM
No Jim, There is a mounting plate for an independent router that mounts on the saw arbor side in the groove for the saw guard. 3450RPM is way too slow!!
Joe
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.