Mike Heidrick
10-07-2008, 12:20 AM
The newest Laguna Platnium horizontal slot mortiser will not mortise a 3/4" thick board out of the crate. Here was my solution: 3/4" BB plywood with rare earth magnets embedded in the bottom sized to fit the existing table width, added some Kreg Klamp track. Put 3/4" BB in the middle as well - it will get a Miter track as well very shortly and this piece screws on and is replaceable/changeable. Then I made brackets that hold the posts for my air-clamps that I got from JDS from their multirouterm (thanks John). These ride in the Klamp track. I can also use regular Kreg Klamps. Also the Kreg blocks square up everything. I like it!
The air clamps can also be used in My Kreg station! I will post that in a different thread.
The air clamps can also be used in My Kreg station! I will post that in a different thread.