Scott Summers
10-02-2008, 9:27 PM
Hello All,
I Have an old ULS 25 40 watt that I recently purchased for personal shop use. Probably 20 watts by now. I had to do some repair work on it. The X/Y carriage was not working properly and the power supply in the laser was smoked. I have everything repaired now, but I haven’t cut out anything yet. I just found out that the driver will only work on win98 or older. I ended up running Win98 in Virtual PC on my XP system. I joined this forum so that I can figure out what would be the best software to purchase.
Q: Can this laser engraver do anything more than vector engraving? Photos?
Q: Is there a driver that will work in XP?
Hey I appreciate any advice
Fare thee well
Scott
We are the music makers we are the dreamers of the dream.
O' Shaunessey
I Have an old ULS 25 40 watt that I recently purchased for personal shop use. Probably 20 watts by now. I had to do some repair work on it. The X/Y carriage was not working properly and the power supply in the laser was smoked. I have everything repaired now, but I haven’t cut out anything yet. I just found out that the driver will only work on win98 or older. I ended up running Win98 in Virtual PC on my XP system. I joined this forum so that I can figure out what would be the best software to purchase.
Q: Can this laser engraver do anything more than vector engraving? Photos?
Q: Is there a driver that will work in XP?
Hey I appreciate any advice
Fare thee well
Scott
We are the music makers we are the dreamers of the dream.
O' Shaunessey