Scott Phillips
09-29-2008, 8:51 AM
Guys,
I put together the G0656 jointer and have a few questions for anybody who has one of these.
Is the fence supposed to sit on the tables or should it rest above the tables (if it does, how do you adjust it so it does)?
I thought I aligned the pulleys but there is a lot of vibration in the belt. the machine does not shake at all, but there is a lot of "flutter" in the belt.
I was measuring the flattness of the tables and it appears that the infeed table sags a little - I was measuring with a 4 ft level and I can slip 2 sheets of paper under the level at the end. Is that small enough not to worry about?
Thanks,
Scott
I put together the G0656 jointer and have a few questions for anybody who has one of these.
Is the fence supposed to sit on the tables or should it rest above the tables (if it does, how do you adjust it so it does)?
I thought I aligned the pulleys but there is a lot of vibration in the belt. the machine does not shake at all, but there is a lot of "flutter" in the belt.
I was measuring the flattness of the tables and it appears that the infeed table sags a little - I was measuring with a 4 ft level and I can slip 2 sheets of paper under the level at the end. Is that small enough not to worry about?
Thanks,
Scott