Laser Pro Question

[Stanley Waldrup]

I have a quick question for anyone else running the Laserpro Sprint 30 Watt model. What power setting and Speed are you using to cut 1/8 Birch Plywood. Mine has been running at 1.5 to 1.6 Speed at 100 power and 400PPI.. Just wondering If the Tube may need a recharge. If I remember Right I was able to run at 2.7 Speed at one time but My orginal Log Book went Bye Bye with the guy that Stole the Laptop...
Stanley

[Scott Challoner]

I don't have a setting for 1/8" but 1/16" is 3.6. I don't think 1.5 speed is out of line. Don't forget all plywood is not created equal. You may have gotten it from different source, or your source may have gotten it from a different source.

[Jerry Hay]

I have a LaserPro spirit and I have always had a hard time cutting. Last time I cut Baltic Birch 1/8 I ran it at 1.0 speed 100% power at 1500 dpi.
it cut clean but still left some uncut sections. If you figured it out let me know. I have wasted a lot of material trying to get it to work right.