Robert Ducharme
05-09-2004, 7:37 PM
Earlier I mentioned that I had some stuff to do to the table saw. I finally can gloat because I finished up the preliminary work :D . The pictures below show the original plain Delta Unisaw. Then the saw with the Robland slider, and then finally the saw with the standard Incra fence. :D :D :D
So what is left? As can be seen in the last picture, there is more hardware to hang off the Incra positioning system, I need to make new extension tables out the back, and make my new router table for the right side. Also, can finally hook up the DC to the system. Not sure if I will hang the extra metal table top to the right of the current one before installing the router table. Time will tell.
I was pretty unhappy with the directions supplied by Laguna for the slider :( but the Incra directions more than made up for that! :) The Incra directions were clear with excellent drawings/pictures. I expect the remaining installation instructions will be of the same quality. To handle the situation about the slider, I am documenting the installation information (with detailed pictures) for installing the slider on a Delta Unisaw. I will post that as a separate thread and also send them to Laguna.
I now be table saw enabled. :cool:
So what is left? As can be seen in the last picture, there is more hardware to hang off the Incra positioning system, I need to make new extension tables out the back, and make my new router table for the right side. Also, can finally hook up the DC to the system. Not sure if I will hang the extra metal table top to the right of the current one before installing the router table. Time will tell.
I was pretty unhappy with the directions supplied by Laguna for the slider :( but the Incra directions more than made up for that! :) The Incra directions were clear with excellent drawings/pictures. I expect the remaining installation instructions will be of the same quality. To handle the situation about the slider, I am documenting the installation information (with detailed pictures) for installing the slider on a Delta Unisaw. I will post that as a separate thread and also send them to Laguna.
I now be table saw enabled. :cool: