Anthony Whitesell
09-11-2008, 2:04 PM
Somewhere I saw a jig or plans for a jig to set the router fence to half the width of the workpiece. I found one that Prazi offers but it's too small.
If I remember correctly (I think there was even a photo), there was a pin at either end and one in the center. The center pin went into the router collet. One end pin rested directly against the fence, and the other pin rested against the workpiece which was against the fence.
Does this sound familiar to anyone? If it doesn't ring a bell, do you think the design sounds feasible enough to attempt to build one myself?
If I remember correctly (I think there was even a photo), there was a pin at either end and one in the center. The center pin went into the router collet. One end pin rested directly against the fence, and the other pin rested against the workpiece which was against the fence.
Does this sound familiar to anyone? If it doesn't ring a bell, do you think the design sounds feasible enough to attempt to build one myself?