Thanks for all your help

[Don Sims]

I had a little alignment issue today on my Pinnacle engraver. All of a sudden it was doing a ghost/double image on the x axis. I went looking on the site for issues in the past for this and got a lot of answers. I read about the trickle voltage fix, does not apply to this problem, but will fix another. I read about bad X motors, dirty tracks, loose belts, ect. What I found was a loose pully on the crossover from the x motor and the x track. I know I did not go out asking for help, but your past help to others trickled down to me. so I say again, thanks to everyone that helps people out on this board.

Don

[Mike Null]

Glad you found what you needed and smart of you to use the search feature for examinaing the archives.