Jerry Bittner
08-11-2008, 1:23 PM
I need some ideas about how to build a crib with a sleigh type top to the two ends -- see attached picture.
I built a jewelry box that has similar curved sides that were achieved by running the stock thorugh the table saw at about a 28 degree angle. So in this instance, I would end up with a curved piece of about 3 to 4" in width and simply dowel it to the end pieces which will probably end up 3/4 oak plywood.
Another suggestion is to rout the channel; and another is to use the Carvewright machine.
Your ideas please.
I built a jewelry box that has similar curved sides that were achieved by running the stock thorugh the table saw at about a 28 degree angle. So in this instance, I would end up with a curved piece of about 3 to 4" in width and simply dowel it to the end pieces which will probably end up 3/4 oak plywood.
Another suggestion is to rout the channel; and another is to use the Carvewright machine.
Your ideas please.