Richard Allen
04-30-2004, 11:14 AM
Hi Howard
I hadn't heard how the quit smokeing thing was going. I figured if I was wondering maybe some others would be wondering the same thing.
This is the power tool forum so I guess there should be something about power tools as well.
I have a short thin board attached at one end to a much thicker piece of wood (actualy the same piece of wood). The thin board isn't an even thickness nore is it perfectly flat. I have been using a ROS with 60 grit to try and flaten the board. This is slow going.
Any ideas about how I might flatten this board?
Thanks
I hadn't heard how the quit smokeing thing was going. I figured if I was wondering maybe some others would be wondering the same thing.
This is the power tool forum so I guess there should be something about power tools as well.
I have a short thin board attached at one end to a much thicker piece of wood (actualy the same piece of wood). The thin board isn't an even thickness nore is it perfectly flat. I have been using a ROS with 60 grit to try and flaten the board. This is slow going.
Any ideas about how I might flatten this board?
Thanks