View Full Version : Shop Notes with Hinge Mort Jig (#74)???
Jay Yoder
08-08-2008, 9:31 AM
I need to make some hinge mortises and i came across an interesting design for a jig that appeared in Shop Notes Issue #74. Does anyone out there have this issue? My first issue started at #84. Go Figure! Has anyone built this jig?
Joe Scharle
08-08-2008, 3:56 PM
I built it when the issue arrived. It had an error and I contacted Shopnotes, but never heard if they corrected it. Error is the base blank should be 10" and they show it as 7 1/2". That's the size after cutting off the sliding fence. Anyway I use it and it works fine. Here's an old pic; I glued a small acrylic baseplate to my Rotozip because the original plan was pre bearing mounted mortising bit availability.
Joe
http://www.ncwoodworker.net/pp/data/194/thumbs/Hinge_Mortise_Jig_4_.jpg (http://www.ncwoodworker.net/pp/data/194/Hinge_Mortise_Jig_4_.jpg)
Jay Yoder
08-09-2008, 12:08 PM
so the mortise jig was for a rotozip?
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.