Pete Thomas(UK)
07-18-2008, 8:04 PM
Hi,
Can any one give me some help here. I have set up a sheet of acrylic and got 10 awards to raster on a sheet 24 x12. All going OK until 3/4 down the work i started to get lines engraved across the width of the work for about 1 inch on the y axis. Then it cleared up. The lines started from the edge of a sail outline on the right hand side of the machine and ran across to the left hand side. The machine is an Epilog 24TT. Any Ideas? Corel Draw or machine?
Thanks in anticipation.
Pete
Can any one give me some help here. I have set up a sheet of acrylic and got 10 awards to raster on a sheet 24 x12. All going OK until 3/4 down the work i started to get lines engraved across the width of the work for about 1 inch on the y axis. Then it cleared up. The lines started from the edge of a sail outline on the right hand side of the machine and ran across to the left hand side. The machine is an Epilog 24TT. Any Ideas? Corel Draw or machine?
Thanks in anticipation.
Pete