Shari Loveless
07-15-2008, 1:09 PM
Hey cnc carvers,
I want to be able to quickly remove chips from the edges of alligator juniper slabs I've carved. I'm talking fairly large chip removal. I don't really want to create this with Artcam. I would rather just do it by hand. Slabs range from 2 to 3" thick and from 16 to 30" tall x 50 to 80" long. For the one in the pic I used a hand chisel and hammer and a grinder to round up the chiseling a little then used a torch on it. I've been looking at the Arbortech Power chisel and mini grinder. Have any of you guys used one of these?
thanks,
Shari
I want to be able to quickly remove chips from the edges of alligator juniper slabs I've carved. I'm talking fairly large chip removal. I don't really want to create this with Artcam. I would rather just do it by hand. Slabs range from 2 to 3" thick and from 16 to 30" tall x 50 to 80" long. For the one in the pic I used a hand chisel and hammer and a grinder to round up the chiseling a little then used a torch on it. I've been looking at the Arbortech Power chisel and mini grinder. Have any of you guys used one of these?
thanks,
Shari