Bosch 1640 flush cut

[Jay Yoder]

Hi all. I recently came across the neatest tool. Does anyone out there have this? The first job i would use it for, would be to trim some aluminum siding. Will the blades hold up for this? I need to trim some siding back on the existing house, so i can slide the panel flush, thus creating a tight joint, which should be easier to seal up...i figured this would help me...i know aluminum is pretty soft, and i am not sure i have any other way to get in there...any input or alternate ideas to a somewhat expensive limited usage tool? thanks alot!!

[Dennis Lopeman]

I have a Fein MultiMaster - it's a similar tool to yours... but has a lot of functions... and tool accessories - esp one for your need...

I found one off Craigslist for $100 used. About the cost of a new Bosch...