John Pelino
06-15-2008, 12:43 PM
I have a used PM66 that I'm having problems with. I suspect it may be they arbor bearings but I'm only guessing as I've never used anything other than a contractor saw in the past.
The saw it not leaving a clean edge on the wood. If I place the fresh cut against a straight edge, I notice the cut edge is wavy. I've tried other blades with better results (thinner kerf) but not as good as what they produced on the other saw. It does not appear to me to be loud or making strange noises - its actually quiter than my old saw. There are little to no vibrations. The blade appears to "wobble" at startup and shutdown but I'm not 100% certain.
I appreciate any advice you may have if you've had a similar problem.
The saw it not leaving a clean edge on the wood. If I place the fresh cut against a straight edge, I notice the cut edge is wavy. I've tried other blades with better results (thinner kerf) but not as good as what they produced on the other saw. It does not appear to me to be loud or making strange noises - its actually quiter than my old saw. There are little to no vibrations. The blade appears to "wobble" at startup and shutdown but I'm not 100% certain.
I appreciate any advice you may have if you've had a similar problem.