John Fruen
06-13-2008, 11:23 AM
Hi, CAN ANYBODY HELP !?!?
I send the work to the laser it appears on the versa screen.
When I run it with the lid up the red dot shows following the engraving path. (eliminating mirror alignment)
I close the lid and run it to engrave, the carriage goes through the motion
but laser does not fire.
It works perfectly OK on flat engraving.
Any ideas, if i had hair i'd be pulling it out with this one.
John
I send the work to the laser it appears on the versa screen.
When I run it with the lid up the red dot shows following the engraving path. (eliminating mirror alignment)
I close the lid and run it to engrave, the carriage goes through the motion
but laser does not fire.
It works perfectly OK on flat engraving.
Any ideas, if i had hair i'd be pulling it out with this one.
John