Dan Mages
06-11-2008, 7:19 AM
Good evening
I want to add programmable thermostats to a zoned furnace setup. It uses a Tol-A-Temp zoning system, pictured below. I purchased Ritetemp 6035 touch screen thermostats from Home Depot to replace the dial type units throughout the house. I reviewed the installation instructions, but cannot find a matching wire scheme. There are three wires on the back of the old thermostat, red, white, and blue. The new thermostat has approximately 12 terminals and I am not sure which I should use. The furnace is made by Thermoflo
A few pictures...
The dampers
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0241.jpg
The control Panel
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0246.jpg
The thermostats
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0250-1.jpg
Thanks!!!
Dan
I want to add programmable thermostats to a zoned furnace setup. It uses a Tol-A-Temp zoning system, pictured below. I purchased Ritetemp 6035 touch screen thermostats from Home Depot to replace the dial type units throughout the house. I reviewed the installation instructions, but cannot find a matching wire scheme. There are three wires on the back of the old thermostat, red, white, and blue. The new thermostat has approximately 12 terminals and I am not sure which I should use. The furnace is made by Thermoflo
A few pictures...
The dampers
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0241.jpg
The control Panel
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0246.jpg
The thermostats
http://img.photobucket.com/albums/v647/DanMages/100%20Cleveland%20Rd/100_0250-1.jpg
Thanks!!!
Dan