Tom Sweeney
02-13-2003, 8:54 PM
I was just posting about a box I'm working on when I thought of a question on doing box joints.
I'm not sure why but the box joints on the 2 sides of the box don't line up.
Do you cut both sides at the same time? I used a table saw with a wobble dado blade (I Know):eek: & a simple box joint jig that I built.
I'm thinking that next time I could do both of the sides at the same time & use double sided tape to hold them aligned then run them through with the jig. then I would just do the front & back the same way. & they should all line up.
Is this a good idea? :confused:
I'm not sure why but the box joints on the 2 sides of the box don't line up.
Do you cut both sides at the same time? I used a table saw with a wobble dado blade (I Know):eek: & a simple box joint jig that I built.
I'm thinking that next time I could do both of the sides at the same time & use double sided tape to hold them aligned then run them through with the jig. then I would just do the front & back the same way. & they should all line up.
Is this a good idea? :confused: