Richard Dooling
05-24-2008, 3:32 PM
I just picked up a Sprunger NJ 6 jointer. It needs some work but appears to be servicable. Anyone know if there are parts anywhere? I also would like to see a manual, I found some good info on the OWWM site but not a lot.
Also, there is a lock knob on the infeed table but none on the out feed table. I have found some pictures of the machine and this appears to be correct. I think that since the outfeed table is seldom adjusted that it is held in place by tightening the gib screws. The main missing part is the guard and a belt/pully cover. I imagine I can rig something up for that.
Any guidance is appreciated.
Also, there is a lock knob on the infeed table but none on the out feed table. I have found some pictures of the machine and this appears to be correct. I think that since the outfeed table is seldom adjusted that it is held in place by tightening the gib screws. The main missing part is the guard and a belt/pully cover. I imagine I can rig something up for that.
Any guidance is appreciated.