tom holton
05-22-2008, 11:38 AM
I am taking delivery of my new Steel City 3HP tomorrow. For some reason, it feels like I want to take more time and be much more exact with setting up this "Big Boy Saw" as compared to my last Ryobi BT3100.
Can you all give me some tips on the setup? I'm planning on following directions, but other than that, I have no tricks up my sleeve. More importantly, what to do after its set up. ie, wax this, dry lube this, verify this, etc...
Also, it might be as simple as wood shims, but what is advised to level the saw on my slightly sloping garage floor?
Do i need a specific straight edge or will a good level do to check wing alignment?
Lots of questions and I dont even have it yet.
much thanks,
Tom
Can you all give me some tips on the setup? I'm planning on following directions, but other than that, I have no tricks up my sleeve. More importantly, what to do after its set up. ie, wax this, dry lube this, verify this, etc...
Also, it might be as simple as wood shims, but what is advised to level the saw on my slightly sloping garage floor?
Do i need a specific straight edge or will a good level do to check wing alignment?
Lots of questions and I dont even have it yet.
much thanks,
Tom