Derek Kern
05-13-2008, 3:52 PM
Just did some metal cutting with a Kern/Synrad 400 watt system. Wanted to share the results.
1/8" at 1"/sec and 95% power
1/4" at .3"/sec and 95% power
5 psi of o2 piercing, 40 psi of o2 cutting, 500 freq.
Results:
1/8" smooth clean cut, no slag on bottom side.
1/4" starts to ripple a bit and little bit of slag.
Enjoy the pics!
http://www.kernlasers.net/img/sawmillcreek/IMG_1082.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1081.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1084.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1087.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1089.jpg
1/8" at 1"/sec and 95% power
1/4" at .3"/sec and 95% power
5 psi of o2 piercing, 40 psi of o2 cutting, 500 freq.
Results:
1/8" smooth clean cut, no slag on bottom side.
1/4" starts to ripple a bit and little bit of slag.
Enjoy the pics!
http://www.kernlasers.net/img/sawmillcreek/IMG_1082.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1081.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1084.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1087.jpg
http://www.kernlasers.net/img/sawmillcreek/IMG_1089.jpg